User guide
Registration 37
9.9 To switch ECO mode on / off
You can switch on ECO mode to reduce the level of power
emissions and save battery power.
1.
Press
Menu
, scroll D to
Settings
and press
Select
.
2.
Scroll D to
Set Base
and press
Select
.
3.
Scroll D to
ECO Mode
and press
Select
.
4.
Scroll U or D to
Off
or
On
then press
Select
to confirm.
5.
Press O to return to standby mode.
NOTE
When the ECO mode is set to ON, the icon is replaced
with icon. The base transmission power will be reduced.
10. Registration
Up to 5 handsets can be registered to one base station.
Additional handsets must be registered to the base before
you can use them.
• The instructions described below apply specifically to the
CD1 handset. If you wish to register another
manufacturer’s handset, the instructions may vary. In this
case, please refer to the instruction manual of the
additional handset.
• The System PIN is required to register or unregister
handsets. The default PIN is 0000.
10.1 To register a handset
On the base:
1.
Press and hold B for 3 seconds until the base LED
starts flashing. The base will remain in registration mode
for 90 seconds.
On the handset:
1.
If the handset is new, the display shows
Please register
.
Press
Menu
, scroll D to
Registration
and press
Select
.
Or
If the handset has already been registered to another
base, the standby display is shown. Press
Menu
, scroll
D to
Registration
and press
Select
.
Motorola_CD1_IFU_EN_UK.book Page 37 Wednesday, December 22, 2010 3:40 PM