Install guide

2-2 CB3000 Client Bridge Quick Install Guide
Prerequisite Requirements
The following hardware and software resources are required to install and operate a CB3000:
PC to be used during device configuration. The PC must have an RJ-45 Ethernet port and a CDROM
drive. The PC must be running the following:
Windows 2000 or XP operating system
Internet Explore 5.0 (or higher) or Netscape 6.0 (or higher)
•An Access Point (AP) (for infrastructure mode operation) or a networked client (for Ad Hoc mode peer-to-
peer operation).
Verifying the Package Contents
Before installing the CB3000, verify the package contains the following:
CB3000 Installation Guide (this guide)
CB3000 Software and Documentation CDROM
CB3000 Client Bridge (Part No. CB-3000-0010-WWR)
Ethernet cable
Power adapter with 5 localized plugs
Single detachable omni-directional antenna.
Mounting hardware.
CAUTION: Only qualified and approved antennas can be used with the CB3000.
NOTE: Contact the Motorola Support Center to report any missing or improperly functioning
components.
Verifying the Installation Site
Mounting options for the CB3000 include table top, wall or under a counter mounting using the keyholes and
mounting hardware provided with the unit.
Before installing CB3000, verify the installation site meets the following requirements:
The Environmental Specifications as defined in the “Technical Specifications” section of this guide.
The site should have access to a properly rated power source.
The site should be dry and within 100 meters of the device(s) (hub, telephone, computers, point-of-sale)
to be connected to the CB3000.
The site should not be near other equipment (transformers, fluorescent lights etc.) that could interfere
with the CB3000’s radio transmissions.
The site should be within 250 ft. of the access point the CB3000 is targeting for association.