User guide

Canopy T1 / E1 Application Note
Issue 1, June 2005 11
Device Information
5.7GHz — BackHaul — Timing Master — 20 Mbit — 0a-00-3e-f1-55-46
Parameter Value
Timing Mode
Timing Master
Timing Slave
Modulation
Scheme
10 Mbits/Second (2 Level)
20 Mbits/Second (4 Level)
Sync Input
Sync to Received Signal (Power Port)
Sync to Received Signal (Timing Port)
Generate Sync Signal
Link Negotiation
Speeds
10 Base T Half Duplex
10 Base T Full Duplex
100 Base T Half Duplex
100 Base T Full Duplex
RF Frequency Carrier
5765
Downlink Data
50
%
Color Code
0
(0—254)
Display-Only
Access
Password: No
Password
Password:
Figure 6. Setting the Canopy unit to 100Mbps Full Duplex mode
5.4 TMUX Cable Length Setting
The TMUX receives from and transmits into the RJ45 T1/E1 port. To accomplish this
properly it must set its Rx sensitivity and Tx power level appropriately. Thus the T1/E1
cable length must be classified into one of the four length settings specified.