User guide

45 Mbps Backhaul User Guide
Issue 3, December 2004 Page 54 of 113
Figure 25 Software Upgrade Complete
When the software image has been written to non-volatile memory Figure 25 will be displayed showing the
status of the software upload.
Reboot the unit by clicking the Reboot Unit button. This will reboot the unit within 30 seconds, during this time
you will not be able to communicate with the unit. The unit is now fully functional.
If this screen is not displayed after 60 seconds this could indicate a problem with the memory update process.
The user should now power cycle the unit to start using the new software image. The unit’s boot software will
automatically determine the health of the newly uploaded software image. If any problems were encountered
the boot code will revert to a protected fixed software image
After the power cycle the user should check that the required software image is loaded and running by re-
entering the Upgrade page where the software bank status will be displayed.