User guide

45 Mbps Backhaul User Guide
Issue 3, December 2004 Page 43 of 113
6.3.3 Install Pages
These pages are used during system installation. There follows a description of the install pages along with their
use during the installation configuration process. The actual installation process is described in section 5.7.9
“Aligning the ODUs”.
All wireless links are shipped as paired units. They are pre-configured at the factory so that they can be installed
without the user supplying any configuration. Each wireless link is shipped with a quick start guide. Attached to
the quick start guide is a summary of the pre-configured configuration data.
Table 4 shows an example link configuration. The values highlighted have been committed to the wireless units
non-volatile storage.
Table 4 45 Mbps Backhaul Factory Configuration Values
The factory default configuration is written to the ‘semi-permanent’ configuration bank.
The factory default configuration is limited in range to 40 Km. If you wish to install a wireless link with
a range of > 40 Km and < 200 Km you must follow the ‘Manually Configuring The Wireless Units’ in
section 6.3.3.1.
The factory default configuration is set to Region 1. Region 1 allows the 45 Mbps Backhaul a maximum
transmit power of 24 dBm. If the local 5.8 GHz regulatory regime limits the maximum transmit power
(EIRP) to less than 24 dBm you should obtain a new license key from your local distributor or direct from
Motorola. Alternatively in the short term, you should reduce the maximum transmit power by following the
‘Manually Configuring The Wireless Units’ in section 6.3.3.1.
6.3.3.1 Manually Configuring The Wireless Units
If the installer!/!system administrator wishes, they may modify the default installation configuration. If only the
IP addresses are incorrect it is recommended that the values are changed via the configuration menu (Section
6.3.1). If any other parameters require modification then it is recommended that the system administrator use
the Installation Wizard.
A detailed description of the Installation Wizard follows:
Example 45 Mbps Backhaul Configuration Data
For your convenience these two units have been
pre-configured as a link
Units:
ODU serial number
ODU serial number
0167800002BE
0167800002BF
Ethernet MAC address
Ethernet MAC address
00:04:56:00:02:BE
00:04:56:00:02:BF
Configured as:
Master
Slave
Target MAC address
Target MAC address
00:04:56:00:02:BF
00:04:56:00:02:BE
License Key
License Key
A471-FE88-428D-E1F3
534F-4F54-D1B0-E2DA
IP Address
IP Address
169.254.1.2
169.254.1.1