User guide

45 Mbps Backhaul User Guide
Issue 3, December 2004 Page 24 of 113
Step 3: Arrange conductors as shown in
Figure 7 and cut to length
Step 4: Insert conductors and crimp
Figure 6 Completed ODU connector
Both ends of the ODU cable are terminated in the same way. Repeat steps 2, 3, and 4 for the PIDU end of the
cable. Note: The PIDU end of the cable does not employ a cable gland.
Figure 7 RJ45 Pin Connection
5.7.2 Making the Connection At The ODU
The following procedure describes how connection is made at the ODU. It is often easier to carry out this
procedure on the ground or a suitable surface prior to mounting the ODU.
Ensure no power is connected to the PIDU or present on the cable before connecting the ODU.