User guide

45 Mbps Backhaul User Guide
Issue 3, December 2004 Page 22 of 113
5.5 Legal Disclaimer
IN NO EVENT SHALL MOTOROLA BE LIABLE FOR ANY INJURY TO ANY PERSONS OR ANY
DAMAGE CAUSED DURING THE INSTALLATION OF THE MOTOROLA 45 Mbps Backhaul
PRODUCT.
5.6 Mounting the ODUs
The ODU mounting bracket is designed to ease installation by mounting the bracket to a wall or pole and then
bringing the ODU into position and attaching using a single bolt. The ODU should be mounted using the
following steps ensuring that the cable entry is at the bottom: NOTE: There should be no reason to change the
orientation of the pre-fitted ODU bracket for either pole or wall mount, provided the fitting instructions are
followed.
The enclosure and mounting brackets of the ODU are capable of withstanding wind speeds up to 151mph
(242kph). The installer should ensure that the structure the ODU is attached to is also capable of withstanding
the prevalent wind speeds and loads. See Section 10 “Wind Loading”.
5.6.1 Pole Mounting
Step 1: Mount the bracket to the pole.
Step 2: Mate the unit to the bracket together
and tighten the nut and bolt.
5.6.2 Wall Mounting
Select and use high quality wall mounting hardware. Note that wind loading can be very high (many
times the weight of the unit) depending upon the location chosen. Also ensure that the wall can withstand
these high forces.