User guide

March 2005 Understanding Canopy Networks
Through Software Release 6.1
Page 46 of 425 Issue 1
Canopy System User Guide
Approved Ethernet cables can also be ordered as bulk cable:
◦ CA-0287
◦ CA-0287S (shielded)
Canopy-approved antenna cables can be ordered in lengths up to 100 ft (30.4 m),
as listed in Table 9.
Table 9: Recommended antenna cables
Part # Description
BT-0564 N TO N GPS antenna cable for CMM2
BT-0716 BNC TO N GPS antenna cable for CMMmicro
Category 5 Cable Tester
For purchase within the U.S.A., the CTCAT5-01 Cable Tester is available.
Override Plug
An override plug (sometimes called a default plug) is available to provide access to a
module whose password and/or IP address have been forgotten. This plug allows the AP,
SM, or BH to be accessed using IP address 169.254.1.1 and no password. During the
override session, you can assign any new IP address and set either or both user
passwords (display-only and/or full access) as well as make other parameter changes.
This plug is available from Best-Tronics Manufacturing, Inc. at
http://www.best-tronics.com/motorola.htm
as Part BT-0583 (RJ-11 Default Plug).
Alternatively if you wish, you can fabricate an override plug, using instructions provided in
Procedure 40 on Page 300.
Alignment Headset
The ACATHS-01 Alignment Headset facilitates the
operation of precisely aiming an SM toward an AP (or
a BHS toward a BHM). This device produces infinitely
variable
◦ pitch, higher when the received signal is
stronger.
◦ volume, louder when jitter is less.
An ACATHS-01 is pictured in Figure 17.
Figure 17: ACATHS-01
alignment headset