User guide

Canopy System Reference Information March 2005
Through Software Release 6.1
Issue 1 Page 397 of 425
Canopy System User Guide
config modify esn esn [skey|suldr|sdldr|ulba|dlba][allowhg] value
Reset the specified ESN to the specified data rate or burst allocation.
NOTE: This command is for execution in only Releases 2.0 and later. Rules are as
defined above.
RULES: All options as above, but also
allowhg
request from the license management server a floating Cap 2
(uncapping) license for the SM when the SM registers with suldr
and sdldr values that sum to greater than 7000 kbps, unless the SM
already has Cap 2. Value must be either 1 (enable) or 0 (disable).
IMPORTANT!
The following commands suspend or reinstate subscriber access. When
you suspend (or reinstate) access by using the BAM SSE command line
interface, access is immediately suspended (or reinstated) for the
subscriber—a current session is dropped (or registration is now allowed).
By contrast, when you suspend (or reinstate) access by selecting
Suspend (or Active) in the BAM GUI, access is not suspended (or
reinstated) until the next registration attempt from the subscriber.
config delete esn esn
Remove the specified ESN from the database.
config disable esn esn
Immediately disable the specified ESN in the database. (See IMPORTANT above.)
NOTE: This command is for execution in only Releases 2.0 and later.
config enable esn esn
Immediately enable the specified ESN in the database. (See IMPORTANT above.)
NOTE: This command is for execution in only Releases 2.0 and later.
config enable esn esn featurename
Immediately enable the feature featurename for the specified ESN.
RULES:
featurename
cir, CIR, vlan, or VLAN.
config disable esn esn featurename
Immediately disable the feature featurename for the specified ESN. Rules are as
defined above.