User guide

Managing Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 301 of 425
Canopy System User Guide
3. Short (solder together) Pins 4 and 6 on the other end. Do not connect any other
wires to anything. The result should be as follows:
Pin
1 → white / orange ← Pin 1
Pin 2 → white / green ← Pin 2
Pin 3 → white / blue ← Pin 3
Pin 4 → green ← Pin 6
Pin 5 → blue ← Pin 5
Pin 6 → orange ← Pin 4
end of procedure
Using the Override Plug
IMPORTANT!
While the override plug is connected to a module, the module can
neither register nor allow registration of another module.
To regain access to the module, perform the following steps.
Procedure 41: Regaining access to a module
1. Insert the override plug into the RJ-11 GPS utility port of the module.
2. Power cycle by removing, then re-inserting, the Ethernet cable.
RESULT: The module boots with the default IP address of 169.254.1.1, password
fields blank, and all other configuration values as previously set.
3. Wait approximately 30 seconds for the boot to complete.
4. Remove the override plug.
5. Set passwords and IP address as desired.
6. Change configuration values if desired.
7. Click Save Changes.
8. Click Reboot.
end of procedure