User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 280 of 425 Issue 1
Canopy System User Guide
10. On the computing device, access the Alignment page of this module. An example
of the Alignment screen is displayed in Figure 112.
Figure 112: Alignment screen
11. In the RF Carrier Frequency field, select the frequency that the BHM transmits.
12. In the RSSI Only Mode field, ensure that the Disabled button is selected.
13. To use the LEDs for coarse alignment: (instead of the Audible Alignment Tone
feature), perform the following steps:
a. On the computer, click Enable Aiming Mode.
NOTE: This places the module into the Normal Aiming Mode. The module is
automatically placed into the Operating Mode after 15 minutes. To return the
module to the Operating Mode before this interval has expired, click Disable
Aiming Mode. To return the module to an aiming mode after this interval has
expired, click Enable Aiming Mode.
b. At the module, observe the six status LEDs in the module. See Figure 47 on
Page 132.
c. Move the module slightly in the vertical plane until the largest number of
LEDs is lit.
14. To use the Audible Alignment Tone feature for coarse alignment (in Release 4.0
and later), perform the following steps:
a. On the computer, click Disable Aiming Mode.
b. Connect the cable to the RJ-11 port of the SM.