User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 277 of 425
Canopy System User Guide
Figure 110: Mounting assembly, exploded view
19.10 INSTALLING A BH TIMING MASTER
To install the Canopy BHM, perform the following steps:
Procedure 34: Installing the BHM
1. If this is a 20-Mbps BH, set the Modulation Scheme parameter in the
Configuration web page of the BHM to 10 Mbps (for easier course aiming).
2. Remove power from the BHM.
3. Choose the best mounting location for your particular application.
4. Optionally, attach the BHM to the arm of the Canopy Passive Reflector dish
assembly as shown in Figure 111.
RECOMMENDATION:
The arm is molded to receive and properly aim the module relative to the
aim of the dish. Stainless steel hose clamps should be used for the
attachment.