User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 271 of 425
Canopy System User Guide
19.6.6 Verifying CMMmicro Connections
To verify the CMMmicro connections after the APs and or BHs have been installed,
perform the following steps.
Procedure 31: Verifying CMMmicro Connections
1. Access the web-based interface for each AP or BH by opening
http://<ip-address
>, where the <ip-address> is the address of the individual
module.
2. In the Status page, verify that the time is expressed in GMT.
3. In the menu on the left-hand side of the web page, click on GPS Status.
4. Verify that the AP or BH is seeing and tracking satellites. (To generate the timing
pulse, the module must track at least 4 satellites.)
end of procedure
19.7 INSTALLING AN SM
To install the Canopy SM, perform the following steps:
Procedure 32: Installing the SM
1. Choose the best mounting location for your particular application.
2. Select the type of mounting hardware appropriate for this location.
3. Remove the base cover of the SM. (See Figure 47 on Page 132.)
4. In the powered down state, attach the cables to the SM.
(See Procedure 8 on Page 143 and Figure 106 on Page 272.)
5. Optionally, attach the SM to the arm of the Canopy Passive Reflector dish
assembly as shown in Figure 105.
RECOMMENDATION:
The arm is molded to receive and properly aim the module
relative to the aim of the dish. Use stainless steel hose
clamps for the attachment.