User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 253 of 425
Canopy System User Guide
Site Location
Enter information about the physical location of the module. This parameter is written into
the sysLocation SNMP MIB-II object and can be polled by an NMS. The buffer size for
this field is 128 characters.
The Configuration page also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Undo Saved Changes
When you click this button, any changes that you made but were not committed by a
reboot of the module are undone.
Set to Factory Defaults
When you click this button, all configurable parameters on all configurable pages are
reset to the factory settings.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Whenever you change a parameter in the Configuration page, the system highlights the
Reboot button as a reminder that a reboot (in addition to a save) is required to implement
the changes.