User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 250 of 425 Issue 1
Canopy System User Guide
Webpage Auto Update
Enter the frequency (in seconds) for the web browser to automatically refresh the web-
based interface. The default setting is 0. The 0 setting causes the web-based interface to
never be automatically refreshed.
Figure 94: Configuration screen, BHS (continued)
As shown in Figure 94, the Configuration page continues with the following parameters.
SM Power Up Mode With No 802.3 Link
Specify the default mode in which this BHS will power up when the BHS senses no
Ethernet link. Select either
◦ Power Up in Aim Mode—the BHS boots in an aiming mode. When the BHS
senses an Ethernet link, this parameter is automatically reset to Power Up in
Operational Mode. When the BHS senses no Ethernet link within 15 minutes
after power up, the BHS carrier shuts off.
◦ Power Up in Operational Mode—the BHS boots in Operational mode and
attempts registration. This is the default selection.