User guide

Guide To This User Guide March 2005
Through Software Release 6.1
Issue 1 Page 25 of 425
Canopy System User Guide
1 NEW IN THIS ISSUE
In Issue 1 of this user guide, this section is a placeholder where changes will be listed in
future issues.
1.1 PRODUCTS COVERED BY THIS USER GUIDE
Most Canopy products are covered by this user guide:
◦ 900-MHz AP and SM
◦ 2.4-GHz modules
◦ 5.2-GHz modules
◦ 5.4-GHz modules
◦ 5.7-GHz modules
◦ Cluster Management Module 2 (CMM2)
◦ Cluster Management Module micro (CMMmicro)
◦ Surge Suppressor
1.2 PRODUCTS NOT COVERED BY THIS USER GUIDE
Some specific-use Canopy products are briefly described in this user guide but fully
described in their own separate user guides:
◦ 45-Mbps Backhaul Module. See Canopy 45-Mbps Backhaul User Guide.
◦ Bandwidth and Authentication Manager. See Canopy Bandwidth and
Authentication Manager (BAM) User Guide.
◦ License Manager. See Canopy Networks License Manager User Guide.
◦ T1/E1 Multiplexer. See Canopy T1/E1 Multiplexer User Guide.
1.3 SOFTWARE COMPATIBILITY DESCRIBED IN THIS USER GUIDE
The following sections of this document provide details and caveats about the
compatibility of Canopy products:
◦ Designations on Page 289
◦ Application, Boot, and FPGA Software Upgrades on Page 290
◦ System Release 6.1 Compatibility on Page 291
◦ BAM Software Compatibility on Page 292
◦ CMMmicro Software and Hardware Compatibility on Page 293
◦ MIB File Set Compatibility on Page 293