User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 235 of 425
Canopy System User Guide
− Hi Priority Uplink CIR
− Hi Priority Downlink CIR
For any SM whose Authentication Mode parameter is set to Authentication Required,
the above settings are derived as shown in Table 42.
Table 42: Where feature values are obtained for the SM with authentication required
Where These Values are Obtained in a Sector with
Software Scheduling Hardware Scheduling
Configuration
Source Setting
in the AP
All
MIR
All
VLAN
HPC
All
CIR
All
MIR
All
VLAN
HPC
All
CIR
BAM BAM BAM AP n/a BAM BAM BAM BAM
SM SM SM AP n/a SM SM SM SM
NOTES:
HPC represents the Hi Priority Channel (enable or disable).
CIR is not available to SMs in a sector where Software Scheduling is implemented.
Where BAM is the indication, values in the SM are disregarded.
Where SM is the indication, values that BAM sends for the SM are disregarded.
The high-priority channel is unavailable to older SMs that have Hardware Scheduling
enabled.
Table 43: Where feature values are obtained for the SM with authentication disabled
Where These Values are Obtained in a Sector with
Software Scheduling Hardware Scheduling
Configuration
Source Setting
in the AP
All
MIR
All
VLAN
HPC
All
CIR
All
MIR
All
VLAN
HPC
All
CIR
BAM AP AP AP n/a AP AP AP AP
SM SM SM AP n/a SM SM SM SM
18.4 CONFIGURING A BH TIMING MASTER FOR THE DESTINATION

NOTE:
The 45-Mbps BH is described in the dedicated document Canopy
45-Mbps Backhaul User Guide.