User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 222 of 425 Issue 1
Canopy System User Guide
address assigned in the NAT Private Network Interface Configuration, IP Address
field above. Only one such address is allowed.
Behind this SM, the device that should receive network traffic must be assigned this
address. The system provides a warning if you enter an address within the range that
DHCP can assign.
NAT Public Network Interface Configuration, IP Address
This field displays the IP address of the SM. If DHCP Client is enabled, then the DHCP
server automatically assigns this address.
NAT Public Network Interface Configuration, Subnet Mask
This field displays the subnet mask of the SM. If DHCP Client is enabled, then the DHCP
server automatically assigns this subnet mask.
NAT Public Network Interface Configuration, Gateway IP Address
This field displays the gateway IP address for the SM. If DHCP Client is enabled, then the
DHCP server automatically assigns this gateway IP address.
RF Public Network Interface Configuration, IP Address
Either enable or disable the RF public interface for this SM. Also assign the IP address
for over-the-air management of the SM when the RF public interface is enabled.
RF Public Network Interface Configuration, Subnet Mask
Assigns the subnet mask for over-the-air management of the SM when the RF public
interface is enabled.
RF Public Network Interface Configuration, Gateway IP Address
Assigns the gateway IP address for over-the-air management of the SM when the RF
public interface is enabled.
RECOMMENDATION:
Note or print the IP settings from this page. Ensure that you can readily
associate these IP settings both with the module and with the other data
that you store about the module.
Regardless of whether NAT is enabled, the IP Configuration page also provides the
following buttons.
Save Changes
When you click this button, any changes that you made on the IP Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Undo Saved Changes
When you click this button, any changes that you made but were not committed by a
reboot of the module are undone.