User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 221 of 425
Canopy System User Guide
Figure 82: IP Configuration screen, NAT without DHCP
When NAT (network address translation) is enabled, you may set the following IP
Configuration page parameters.
NAT Private Network Interface Configuration, IP Address
Assign an IP address for SM management. This address is available from only Ethernet
access to the SM. The last characters of this address must be .1. This address becomes
the base for the range of DHCP-assigned addresses.
NAT Private Network Interface Configuration, Subnet Mask
Assign a subnet mask of 255.255.255.0 or a more restrictive subnet mask.
DMZ Host Interface Configuration, IP Address
Either enable or disable DMZ for this SM. See DMZ on Page 117.
Also assign the DMZ IP address to use for this SM when DMZ is enabled. The first three
octets of this address are automatically set as identical to the first three octets of the