User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 217 of 425
Canopy System User Guide
LAN1 Network Interface Configuration, Gateway IP Address
Enter the appropriate gateway for the SM to communicate with the network. The default
gateway is 169.254.0.0.
Regardless of whether NAT is enabled, the IP Configuration page also provides the
following buttons.
Save Changes
When you click this button, any changes that you made on the IP Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Undo Saved Changes
When you click this button, any changes that you made but were not committed by a
reboot of the module are undone.
Set to Factory Defaults
When you click this button, all configurable parameters on all configurable pages are
reset to the factory settings.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Whenever you change a parameter in the IP Configuration page, the system highlights
the Reboot button as a reminder that a reboot (in addition to a save) is required to
implement the changes.
18.2.3 IP Configuration Page of the SM with NAT Enabled
Further examples of SM IP Configuration screens are displayed in
◦ Figure 79 for the NAT with DHCP Client and DHCP Server implementation.
◦ Figure 80 for the NAT with DHCP Client implementation.
◦ Figure 81 for the NAT with DHCP Server implementation.
◦ Figure 82 for the NAT without DHCP implementation.