User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 216 of 425 Issue 1
Canopy System User Guide
Figure 78: IP Configuration screen, NAT disabled, local accessibility
When NAT (network address translation) is disabled on the NAT Configuration page as
shown in Figure 83 on Page 223, the you may set the following IP Configuration page
parameters.
LAN1 Network Interface Configuration, IP Address
Enter the non-routable IP address to associate with the Ethernet connection on this SM.
(The default IP address from the factory is 169.254.1.1.) If you set and then forget this
parameter, then you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 302.
RECOMMENDATION:
Note or print the IP settings from this page. Ensure that you can readily
associate these IP settings both with the module and with the other data
that you store about the module.
LAN1 Network Interface Configuration, Subnet Mask
Enter an appropriate subnet mask for the SM to communicate on the network. The
default subnet mask is 255.255.255.0. See Allocating Subnets on Page 123.