User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 211 of 425
Canopy System User Guide
Figure 76: Configuration screen, SM (continued)
As shown in Figure 76, the Configuration page continues.
SM Power Up Mode With No 802.3 Link
Specify the default mode in which this SM will power up when the SM senses no Ethernet
link. Select either
◦ Power Up in Aim Mode—the SM boots in an aiming mode. When the SM
senses an Ethernet link, this parameter is automatically reset to Power Up in
Operational Mode. When the module senses no Ethernet link within 15 minutes
after power up, the SM carrier shuts off.
◦ Power Up in Operational Mode—the SM boots in Operational mode. The
module attempts registration. This is the default selection.
Bridge Entry Timeout
Specify the appropriate bridge timeout for correct network operation with the existing
network infrastructure. Timeout occurs when the AP encounters no activity with the SM