User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 210 of 425 Issue 1
Canopy System User Guide
If you set and then forget the Full Access password, then you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 302.

NOTE:
You can unset either password (revert the access to no password
required). To do so, type a space into the field and reboot the module.
You must enter any password twice to allow the system to verify that the
password is not mistyped. After any password is set and a reboot of the
module has occurred, a Password Set indicator appears to the right of
the field.
RECOMMENDATION:
Note the passwords that you enter. Ensure that you can readily
associate these passwords both with the module and with the other data
that you store about the module.
Webpage Auto Update
Enter the frequency (in seconds) for the web browser to automatically refresh the web-
based interface. The default setting is 0. The 0 setting causes the web-based interface to
never be automatically refreshed.