User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 207 of 425
Canopy System User Guide
Figure 75: Configuration screen, SM
The Configuration web page contains all of the configurable parameters that define how
the SM operates. The first line of information on the Configuration screen echoes the
Device Type from the Status web page.
As shown in Figure 75, you may set the Configuration page parameters as follows.
802.3 Link Enable/Disable
Specify whether to disallow the SM to send and receive data through the Ethernet port
even when the RF link to the AP is active. This parameter toggles on or off the Browser-
based Disabling of Subscriber Module Ethernet Interface feature in Release 3.2 and later
releases. You can alternatively control this feature from the AP.