User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 206 of 425 Issue 1
Canopy System User Guide
Save Changes
When you click this button, any changes that you made on the IP Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Undo Saved Changes
When you click this button, any changes that you made but were not committed by a
reboot of the module are undone.
Set to Factory Defaults
When you click this button, all configurable parameters on all configurable pages are
reset to the factory settings.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Whenever you change a parameter in the IP Configuration page, the system highlights
the Reboot button as a reminder that a reboot (in addition to a save) is required to
implement the changes.
18.2 CONFIGURING AN SM FOR THE DESTINATION
18.2.1 Configuration Page of the SM
An example of an SM Configuration screen is displayed in Figure 75.