User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 184 of 425 Issue 1
Canopy System User Guide
16.4.10 Configuring Modules for Connection to CMMmicro
After configuring the CMMmicro, configure the APs and BHs as follows. In each AP or BH
that connects to a CMMmicro, you must set the Sync Input parameter of the
Configuration page of that module to Sync to Received Signal (Power Port).
See
◦ Sync Input on Page 190.
◦ Sync Input on Page 237.
16.4.11 Event Log Page of the CMMmicro
This page may contain information that can be useful under the guidance of Canopy
technical support. For this reason, the operator should not clear the contents of this page
before contacting technical support.
16.4.12 GPS Status Page of the CMMmicro
An example of the CMMmicro GPS Status page is displayed in Figure 68.
Figure 68: GPS Status screen, CMMmicro
The GPS Status page provides information from the GPS antenna and information about
the GPS receiver in the CMMmicro.