User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 179 of 425
Canopy System User Guide
Lan1 IP
Enter the IP address to be associated with the Ethernet connection on this CMMmicro.
The default address is 169.254.1.1. If you set and then forget this parameter, then you
must both
1. physically access the module.
2. use the CMMmicro override toggle switch to electronically access the module
configuration parameters at 169.254.1.1. See Overriding Forgotten IP Addresses
or Passwords on CMMmicro on Page 302.
RECOMMENDATION:
Note or print the IP settings from this page. Ensure that you can readily
associate these IP settings both with the module and with the other data
that you store about the module.
LAN Subnet Mask
Enter the appropriate subnet mask for the module to communicate on the network. The
default value for this parameter is 255.255.0.0.
Default Gateway
Enter the appropriate gateway for the module to communicate on the network. The
default for this parameter is 169.254.0.0.
Port Configuration
If you wish to force a port to a speed or duplex state, or to return the module to auto-
negotiating speed and duplex state, change the selection for the port. The range of
selections are defined in Table 38.
Table 38: Port Configuration selections for CMMmicro
Selection Result
Auto
The port attempts to auto-negotiate speed and duplex state.
(This is the default and recommended setting.)
100FDX The port is forced to 100 Mbps and full duplex.
100HDX The port is forced to 100 Mbps and half duplex.
10FDX The port is forced to 10 Mbps and full duplex.
10HDX The port is forced to 10 Mbps and half duplex.
If you change this value for a port and then click Save Changes, then the change
becomes effective immediately and the previous value is lost.
Description
You can enter text in this parameter (for example, text that helps you to associate the
port number with the connected device.) If you change this value for a port and then click