User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 168 of 425 Issue 1
Canopy System User Guide
Site Name
This field indicates the name of the physical module. You can assign or change this
name on the Configuration web page. This information is also set into the sysName
SNMP MIB-II object and can be polled by an SNMP management server.
Site Contact
This field indicates contact information for the physical module. You can provide or
change this information on the Configuration web page. This information is also set into
the sysName SNMP MIB-II object and can be polled by an SNMP management server.
To conclude the test, perform the following steps.
Procedure 20: Verifying and recording information from the BHM
1. Confirm that the GPS Sync Pulse Status field indicates Generating Sync.
NOTE: This indication confirms that the BHM is properly functional.
2. While your browser is set to this BHM Status page, note (or print) the values of
the following fields:
◦ Device type
◦ Software Version
◦ Software Boot Version
◦ FPGA Version
3. Systematically ensure that you can retrieve this data when you prepare to deploy
the BHM.
end of procedure
16.4.7 Configuring a CMMmicro for Test
The layout of the CMMmicro is as shown in Figure 62.