User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 159 of 425
Canopy System User Guide
16.4.3 Sessions Page of the BHM
An example of the BHM Sessions page is displayed in Figure 58.
Figure 58: Example Sessions page data, BHM
If the BHS is not registered to this BHM, then the Sessions page displays the simple
message No sessions. In this case, try the following steps.
Procedure 16: Retrying to establish a point-to-point link
1. More finely aim the BHS toward the BHM.
2. Recheck the Sessions page of the BHM for the presence of the BHS LUID.
3. If the LUID is still not reported on the Sessions page, click the Configuration
button on the left side of the page.
RESULT: The BHM responds by opening the BHM Configuration page.
4. Scroll down to the Color Code parameter and note the setting.
5. In the same sequence as you did for the BHM directly under Configuring a Point-
to-Point Link for Test on Page 153, connect the BHS to a computing device and
to power.
RESULT: The BHS powers up in the Operational mode, opens the SM Status
page, scans, and attempts to register.
6. On the left side of the BHS Status page, click the Configuration button. The
Configuration page of the BHS opens.
7. In the Timing Mode parameter, select Timing Slave.
RESULT: This BH is now forced to receive sync and to provide the distinct set of
web interface pages and parameters for the role of BHS.