User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 158 of 425 Issue 1
Canopy System User Guide
If you must set the time and date, use the following format for entry:
Time hh:mm:ss
Date mm/dd/yyyy
where
hh
represents the two-digit hour in the range 00 to 24
mm
represents the two-digit minute
ss
represents the two-digit second
mm
represents the two-digit month
dd
represents the two-digit day
yyyy
represents the four-digit year
Proceed with the test setup as follows.
Procedure 15: Setting up the BHS for test
1. Enter the appropriate information in the format shown above.
2. Click the Set Time and Date button.
NOTE: The time displayed at the top of this page is static unless your browser is
set to automatically refresh.
3. In one hand, securely hold the top (larger shell) of the BH that you intend to
deploy as a timing slave. With the other hand, depress the lever in the back of
the base cover (smaller shell). Remove the base cover.
4. Plug one end of a CAT 5 Ethernet cable into the BHS.
5. Plug the other end of the Ethernet cable into the jack in the pig tail that hangs
from the power supply.
6. Roughly aim the BHS toward the BHM.
WARNING!
From this point until you remove power from the BHS, stay at least as far
from the BHS as the minimum separation distance specified under
Preventing Overexposure to RF on Page 127.
7. Plug the power supply into an electrical outlet.
8. Back at the computing device, on the left side of the BHM Time & Date page,
click the Sessions button.
RESULT: The BHM responds by opening the Sessions page.
end of procedure