User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 156 of 425 Issue 1
Canopy System User Guide
4. At the bottom of this page, select Generate Sync Signal.
5. Click the Go To Next Page => button.
RESULT: The BHM responds by opening the Lan IP Address page.
6. At the bottom of this page, specify
a. a Lan IP Address.
b. a Lan Subnet Mask.
c. a Default Gateway.
7. Click the Go To Next Page => button.
RESULT: The BHM responds by opening the Review and Save Configuration
page.
8. Ensure that the initial parameters for the BHM are set as you intended.
9. Click the Save Changes button.
10. On the left side of the Status page, click the Configuration button.
RESULT: The BHM responds by opening the Configuration page.
11. In the Timing Mode parameter, select Timing Master.
RESULT: This BH is now forced to provide sync for the link and the distinct set of
web interface pages and parameters for the role of BHM.
12. Click the Save Changes button.
13. Click the Reboot button.
RESULT: The BHM responds with the message Reboot Has Been Initiated…
14. Trigger your browser to refresh the page until the BHM redisplays the Status
page.
end of procedure
We encourage you to experiment with the interface. Unless you save a configuration and
reboot the BHM after you save the configuration, none of the changes are effected.
16.4.2 Time & Date Page of the BHM
To proceed with the test setup, click the Time & Date button on the left side of the Quick
Start page. The BHM responds by opening the Time & Date page. An example of the
BHM Time & Date web page is displayed in Figure 57.