User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 155 of 425
Canopy System User Guide
Figure 56: Quick Start screen, BHM
Quick Start is a wizard that helps you to perform a basic configuration that places a BHM
into service. Only the following parameters must be configured:
◦ RF Carrier Frequency
◦ Synchronization
◦ Network IP Address
In each page under Quick Start, you can
◦ specify the settings to satisfy the requirements of the network.
◦ review the configuration selected.
◦ save the configuration to non-volatile memory.
Proceed with the test setup as follows.
Procedure 14: Using Quick Start to configure the BH for test
1. At the bottom of the Quick Start page, click the Let’s Get Started! button.
RESULT: The BHM responds by opening the RF Carrier Frequency page.
2. From the pull-down menu in the lower left corner of this page, select a frequency
for the test.
3. Click the Go To Next Page => button.
RESULT: The BHM responds by opening the Synchronization page.