User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 154 of 425 Issue 1
Canopy System User Guide
7. Start the browser in the computing device.
8. Access the Configuration page of the BH.
9. In the Timing Mode parameter, select Timing Master.
10. Click Save Changes.
11. Click Reboot.
end of procedure
The Canopy BH interface provides a series of web pages to configure and monitor the
unit. These screens are subject to change by subsequent software releases.
You can access the web-based interface through only a computing device that is either
directly connected or connected through a network to the BH. If the computing device is
not connected to a network when you are configuring the module in your test
environment, and if the computer has used a proxy server address and port to configure
a Canopy module, then you may need to first disable the proxy setting in the computer.
To toggle the computer to not use the proxy setting, perform Procedure 6 on Page 139.
In the address bar of your browser, enter the IP address of the BHM (default is
169.254.1.1). The BHM responds by opening the Status page.
16.4.1 Quick Start Page of the BHM
To proceed with the test setup, click the Quick Start button on the left side of the Status
page. The BHM responds by opening the Quick Start page. The standard Quick Start
screen is displayed in Figure 56.