User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 153 of 425
Canopy System User Guide
Site Contact
This field indicates contact information for the physical module. You can provide or
change this information on the Configuration web page. This information is also set into
the sysName SNMP MIB-II object and can be polled by an SNMP management server.
To conclude the test, perform the following steps.
Procedure 12: Verifying and recording information from the AP
1. Confirm that the GPS Sync Pulse Status field indicates Generating Sync.
NOTE: This indication confirms that the AP is properly functional.
2. While your browser is set to this AP Status page, note (or print) the values of the
following fields:
◦ Device type
◦ Software Version
◦ Software Boot Version
◦ FPGA Version
3. Systematically ensure that you can retrieve this data when you prepare to deploy
the AP.
end of procedure
16.4 CONFIGURING A POINT-TO-POINT LINK FOR TEST
Perform the following steps to begin the test setup.
Procedure 13: Setting up the BH for Quick Start
1. In one hand, securely hold the top (larger shell) of the BH that you intend to
deploy as a timing master. With the other hand, depress the lever in the back of
the base cover (smaller shell). Remove the base cover.
2. Plug one end of a CAT 5 Ethernet cable into the timing master.
3. Plug the other end of the Ethernet cable into the jack in the pig tail that hangs
from the power supply.
4. Plug the other connector of the pig tail into the Ethernet jack of the computing
device.
WARNING!
From this point until you remove power from the BH, stay at least as far
from the BH as the minimum separation distance specified under
Preventing Overexposure to RF on Page 127.
5. Plug the power supply into an electrical outlet.
6. Power up the computing device.