User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 144 of 425 Issue 1
Canopy System User Guide
16.3.3 Sessions Page of the AP
An example of the AP Sessions page is displayed in Figure 52.
Figure 52: Example Sessions page data, AP
If no SMs are registered to this AP, then the Sessions page displays the simple message
No sessions. In this case, try the following steps.
Procedure 9: Retrying to establish a point-to-multipoint link
1. More finely aim the SM or SMs toward the AP.
2. Recheck the Sessions page of the AP for the presence of LUIDs.
3. If still no LUIDs are reported on the Sessions page, click the Configuration
button on the left side of the page.
RESULT: The AP responds by opening the AP Configuration page.
4. Scroll down to the Color Code parameter and note the setting.
5. In the same sequence as you did for the AP directly under Configuring a Point-to-
Multipoint Link for Test on Page 138, connect the SM to a computing device and
to power.
RESULT: The SM powers up in the Operational mode, opens the SM Status
page, scans, and attempts to register.