User guide

Building Your Canopy Network March 2005
Through Software Release 6.1
Issue 1 Page 141 of 425
Canopy System User Guide
Procedure 7: Using Quick Start to configure the AP for test
1. At the bottom of the Quick Start page, click the Let’s Get Started! button.
RESULT: The AP responds by opening the RF Carrier Frequency page.
2. From the pull-down menu in the lower left corner of this page, select a frequency
for the test.
3. Click the Go To Next Page => button.
RESULT: The AP responds by opening the Synchronization page.
4. At the bottom of this page, select Generate Sync Signal.
5. Click the Go To Next Page => button.
RESULT: The AP responds by opening the Lan IP Address page.
6. At the bottom of this page, specify
f. a Lan IP Address.
g. a Lan Subnet Mask.
h. a Default Gateway.
7. Click the Go To Next Page => button.
RESULT: The AP responds by opening the Review and Save Configuration
page.
8. Ensure that the initial parameters for the AP are set as you intended.
9. Click the Save Changes button.
10. Click the Reboot button.
RESULT: The AP responds with the message Reboot Has Been Initiated…
11. Trigger your browser to refresh the page until the AP redisplays the Status page.
end of procedure
Canopy encourages you to experiment with the interface. Unless you save a
configuration and reboot the AP after you save the configuration, none of the changes
are effected.
16.3.2 Time & Date Page of the AP
To proceed with the test setup, click the Time & Date button on the left side of the Quick
Start page. The AP responds by opening the Time & Date page. An example of the AP
Time & Date web page is displayed in Figure 51.