User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 140 of 425 Issue 1
Canopy System User Guide
Figure 50: Quick Start screen, AP
Quick Start is a wizard that helps you to perform a basic configuration that places an AP
into service. Only the following parameters must be configured:
◦ RF Carrier Frequency
◦ Synchronization
◦ Network IP Address
In each page under Quick Start, you can
◦ specify the settings to satisfy the requirements of the network.
◦ review the configuration selected.
◦ save the configuration to non-volatile memory.
Proceed with the test setup as follows.