User guide

March 2005 Building Your Canopy Network
Through Software Release 6.1
Page 134 of 425 Issue 1
Canopy System User Guide
16.2.5 CMM2 Component Layout
As shown in Figure 103 on Page 266, the CMM2 comprises four assemblies:
◦ Ethernet switch
◦ Power transformer
◦ Interconnect board
◦ GPS receiver.
Some CMM2s that were sold earlier had four openings in the bottom plate, as shown in
Figure 48. Currently available CMM2s have two additional Ethernet cable and GPS sync
cable openings to allow use of thicker, shielded cables.
GPS sync
cables
N-connector to GPS antenna
Network feed
Power feed
Ethernet cables
Figure 48: Canopy CMM2, bottom view
16.2.6 CMMmicro Component Layout
The layout of the CMMmicro is shown in Figure 49.