Troubleshooting guide

BSR Troubleshooting Guide
4-52
where:
port is the number of the upstream port
4. To determine if modulation profile parameters are adequate for the upstream
port, use the show cable modulation-profile command in Privileged EXEC
mode as shown in the following example:
RDN#show cable modulation-profile <n>
where:
n is the modulation profile number being used.
Figure 4-5 show cable modulation-profile Command Output
5. If a different modulation profile must be set for the upstream port, use the
cable upstream modulation-profile command in Interface Configuration
mode, as shown in the following example:
RDN(config-if)#cable upstream <port> modulation-profile <n>
where:
port is the upstream port.
n is the modulation profile number.