Troubleshooting guide

BSR Troubleshooting Guide
6-104
interface number refers to the ethernet interface number.
4. To change the version of RIP received over the specified interface, use the ip rip
receive version command in Interface Configuration mode, as shown in the
following example:
RDN(config-if)#ip rip receive version <option>
Table 6-3 lists the available command options.
5. To change the version of RIP sent over the specified interface, use the ip rip send
version command in Interface Configuration mode, as shown in the following
example:
RDN(config-if)#ip rip send version <option>
where:
option is the for the version or versions of RIP that are accepted over the
interface.
Note: The BSR 1000 uses the same syntax as the above command, however
the ethernet interface slot and interface number are set to zero.
Table 6-3 IP RIP Receive Version Command Options
Option Description
0 The specified interface can receive RIP version 1 and 2 packets.
1 The specified interface can receive only RIP version 1 packets.
2 The specified interface can receive only RIP version 2 packets.