System information

Configuring the System
3-45
The configuration parameters that you have set should appear in the show
running-config command output.
Reseting BSR Modules
One or all modules on the BSR need to be reset for boot image upgrades, if
significant software errors occur on a particular module or accross several
modules on the BSR, or in instances where POS modules need to be
synchronized.
Use the reset command in Privileged EXEC mode to reset one or all modules on
the BSR, as shown below:
MOT#reset [all | slot {<0-6, 8-15>}]
where:
all resets all modules in the BSR chassis.
slot indicates that a specific module slot is reset.
0-6, 8-15 identifies the module slot number to be reset.
For example, if you are resetting one module, the following syntax applies:
MOT#reset slot 3
For example, if you are resetting all modules on the BSR, the following syntax
applies:
MOT#reset all
Monitoring the System
The following sections provide information about common system management show
commands used to examine system processes:
• Displaying System Processing Information
• Displaying System Memory Information
• Displaying the System Version Information
• Displaying System Buffer Information