System information

Configuring the System
3-37
Follow these steps to download an image file to NVRAM on the SRM:
1. To download an image file to NVRAM, use the copy ftp: nvram: command in
Privileged EXEC mode and press the Enter key, as shown below:
MOT#copy ftp: nvram:
2. Enter the IP address or DNS name of the remote FTP or TFTP server at the
Address or name of remote host prompt and press the Enter key.
For example:
Address or name of remote host[]? 10.10.10.1
3. Enter the full path from the FTP root directory and the new application or boot
image file name after the Source file name prompt and press the Enter key.
Source file name [ ]?
For example:
Source file name [ ]? /pub/image_file.Z
4. The Destination file name prompt displays with the new file name. Press the
Enter key to accept the new file name in NVRAM. For example:
Destination file name [ image_file.Z ]?
The file is successfully copied to NVRAM on the SRM module.
Note: The following steps describe the process of transferring the new image
files from an FTP server to the SRM. If you are using FTP to transfer the
image files, ensure that the FTP username and password are set correctly on
the BSR 64000 using the ip ftp username and ip ftp password commands.
If you are using TFTP to transfer the image files, a username and password
are not necessary and the copy tftp: nvram: command can be substituted
for the copy ftp: nvram: command.
Note: You can optionally rename the image file name stored in NVRAM on
the SRM module. If you decide to enter a new file name in NVRAM on the
SRM, enter the new file name after the Destination file name prompt. For
example:
Destination file name [ image_file.Z ] ? <new file name>