System information

Configuring Packet Over SONET
14-17
MOT(config-if)#pos threshold b1-tca <3-9>
where:
<3-9> is the 10E-3 to 10E-9 Rate.
2. To configure the BER threshold for the b2 TCA, use the pos threshold b2-tca
command in Interface Configuration mode as shown below:
MOT(config-if)#pos threshold b2-tca <3-9>
where:
<3-9> is the 10E-3 to 10E-9 Rate.
3. To configure the BER threshold for the b3 TCA, use the pos threshold b3-tca
command in Interface Configuration mode as shown below:
MOT(config-if)#pos threshold b3-tca <3-9>
where:
<3-9> is the 10E-3 to 10E-9 Rate.
4. To return to the default setting, use the no pos threshold command in POS
Interface Configuration mode as shown below:
MOT(config-if)#no pos threshold [b1-tca | b2-tca | b3-tca] <rate>
where:
rate is the numeric rate of error.
Setting Alarm Reporting
No SONET alarms are reported by default. Refer to Table 14-10 for command option
alarm reporting descriptions. To select SONET alarms to be logged to the POS
interface console, use the pos report command in Interface Configuration mode as
shown below:
MOT(config-if)#pos report [all | b1-tca | b2-tca | b3-tca | lais | lrdi | pais | plop
| prdi | rdool | sd-ber | sf-ber | slof | slos]
To disable logging of selected SONET alarms, use the no pos report command in
POS Interface Configuration mode as shown below: