System information

BSR 64000 Configuration and Management Guide
14-14
4. To configure the j0 byte as a hexadecimal section trace byte, use the pos flag j0
command in Interface Configuration mode, as shown below:
MOT(config-if)#pos flag j0 <hexnum>
where:
hexnum is the hexadecimal value for the j0 byte
.
5. To configure the j0 byte as a 16 byte section trace message, use the pos flag j0
16byte command in Interface Configuration mode, as shown below:
MOT(config-if)#pos flag j0 16byte <string>
where:
string is a text string containing the byte 15 sequence.
6. To configure the j1 byte as a 16 byte path message, use the pos flag j1 16byte
command in Interface Configuration mode as shown below:
MOT(config-if)#pos flag j1 16byte <string>
where:
string is a text string containing the byte 15 sequence.
7. To configure the j1 byte as a 64 byte path message, use the pos flag j1 64byte
command in Interface Configuration mode as shown below:
MOT(config-if)#pos flag j1 64byte <string>
where:
Note: The first byte contains an automatically generated CRC, the remaining
15 bytes are user defined.
Note: The first byte contains an automatically generated CRC, the remaining
15 bytes are user defined.