System information

BSR 64000 Configuration and Management Guide
14-4
Configuring PPP
Table 14-2 describes the PPP features and commands that are available on the POS
module:
Follow these steps to configure PPP on the POS interface:
1. To set the size of the MTU packet allowed on the POS interface, use the ppp mtu
command in Interface Configuration mode, as shown below:
MOT(config-if)#ppp mtu <bytes>
where:
bytes is the number of bytes from permitted for the MTU; value is between
72 to 1500; default is 1500 bytes.
2. To set the number of attempts for successful negotiation before terminating the
PPP link on the POS interface, use the ppp negotiation-count command in
Interface configuration mode, as shown below:
MOT(config-if)#ppp negotiation-count <n>
where:
Table 14-2 PPP Commands
Command Description Default Value
ppp mtu Maximum transmission
unit packet size allowed on
the POS interface
1500 bytes 72 to 1500 bytes
ppp
negotiation-count
Number of attempts before
PPP connection is
dropped
10 attempts 1 to 100 attempts
ppp timeout ncp Maximum wait time for
network layer to negotiate
before PPP connection is
dropped
10 seconds 1 to 2147483
seconds
ppp timeout retry Maximum wait time for a
negotiation response
before PPP connection is
dropped
10 seconds 0 to 2147483