System information

Configuring the System
3-3
For more information on installing the servers, refer to the vendor server software
documentation.
Accessing the CLI to Set System Passwords
Follow these steps to access the CLI from a console session in order to configure
password privileges for enabled modes and telnet:
1. Start your terminal or terminal application to connect to the BSR. Refer to
Chapter 2 for more information on configuring your terminal or terminal
application.
2. Power on the BSR 64000.
3. The terminal session begins and the password prompt displays. The password is a
null value by default. Press the Enter key. The
MOT> prompt displays.
4. To enter Privileged EXEC mode, use the enable command in User EXEC mode,
as shown below:
MOT>enable
The Password prompt displays.
5. To enter Privileged EXEC mode, press the Enter key at the password prompt. The
password is a null value by default.
6. Use the configure command to enter Global Configuration mode in order to set
system passwords, as shown below:
Note: Make sure that the serial cable is connected properly and the terminal
application is configured correctly. Refer to the BSR 64000 Installation Guide
for more information.
Warning: Do not interrupt the boot process.