System information

BSR 64000 Configuration and Management Guide
12-18
Restoring Route Reflection from a Route Reflection Client
By default, the clients of a route reflector are not required to be fully meshed and the
routes from a client are reflected to other clients. However, if the clients are fully
meshed, route reflection with the same set of clients is not required. Also, if
client-to-client reflection is enabled, the clients of a route reflector cannot be members
of a peer group.
In Figure 12-8, the local router is a route reflector. The four neighbors are fully
meshed, so client-to-client reflection is disabled.
Figure 12-8 Disabling Client-to-Client Reflection
To disable client-to-client route reflection, use the no bgp client-to-client reflection
command in Router BGP Configuration mode, as shown below:
MOT(config-bgp)#no bgp client-to-client reflection
AS 100
140.20.10.3
140.20.10.1
140.20.10.2
140.20.10.4 140.20.10.5
Route
Reflector
client
Route
Reflector
client
Route
Reflector
client
Route
Reflector
client
Route
Reflector