System information

Configuring BGP
12-11
Figure 12-4 BGP Peer Groups
You can create a BGP peer group or you can configure a BGP neighbor to be a
member of a BGP peer group using the neighbor peer-group command.
1. To create a BGP peer group, use the neighbor peer-group command in Router
BGP Configuration mode, as shown below:
MOT(config-bgp)#neighbor <name> peer-group
where:
name is the name you assign to the peer group.
2. To assign a BGP neighbor as a member of a BGP peer group, use the neighbor
peer-group command in Router BGP Configuration mode, as shown below:
MOT(config-bgp)#neighbor <ip-address> peer-group <name>
where:
ip-address is the IP address of the neighbor to be assigned to the peer group.
AS 100
AS 200
Philadelphia
AS 300
Trenton
AS 400
Boston
bgp0006
5.5.5.5
6.6.6.6
4.4.4.4
2.2.2.2
3.3.3.3
3.3.3.1
4.4.4.1
2.2.2.1
5.5.5.1
7.7.7.1
6.6.6.1
7.7.7.7
ChicagoSeattle
Dallas
SF