System information

BSR 64000 Configuration and Management Guide
10-22
• The show clns protocol command displays the protocol-specific information for
each IGRP routing process in the router.
Figure 10-4 displays sample show clns protocol command output:
Figure 10-4 show clns protocol Command Output
Table 10-8 describes the show clns protocol command output:
Init System is an IS and is waiting for an IS-IS hello message. IS-IS
regards the neighbor as not adjacent.
Up Regards the ES or IS as reachable.
Holdtime The number of seconds before this adjacency entry times out.
Type The level of the IS-IS router.
Protocol The protocol through which the adjacency was learned. Valid
protocol sources are IS-IS, IGRP, or through a static route.
Table 10-8 show clns protocol Command Output Fields
Output Field Description
IS-IS Router Indicates that the IS-IS protocol is enabled on the BSR.
System Id Identification value of the system.
IS-Type: Indicates the IS-IS routing level (Level 1, Level 2 or both) is enabled
on the router.
Manual area
address(es):
Area addresses that have been configured.
Table 10-7 show clns neighbors Command Output Fields
Output Field Description