System information

BSR 64000 Configuration and Management Guide
10-10
cable is the cable interface.
ethernet is the Ethernet/Fast Ethernet interface.
gigaether is the Gigabit Ethernet interface.
pos is the Packet over SONET interface.
slot is the module slot number.
interface is the interface number.
Configuring IS-IS on an Interface
The following configuration tasks performed on the designated IS-IS interface are
optional. They are used to adapt IS-IS to your network. When you configure IS-IS
parameters on a BSR interface, ensure that they are consistent with other routers on
your network.
• Specifying the Interface Circuit Type of an IS-IS Interface
• Configuring IS-IS Link-State Cost Metrics
• Setting the Advertised Hello Interval
• Specifying the Advertised Hello Multiplier
• Setting the Advertised CSNP Interval
• Setting the LSP Interval
• Setting the LSP Retransmission Interval
• Setting the LSP Retransmit Throttle Interval
• Setting the Designated Router Priority
• Assigning a Password to an IS-IS Interface
Specifying the Interface Circuit Type of an IS-IS Interface
The default IS-IS interface circuit type is for Level 1 and Level 2. Use the isis
circuit-type command in Interface Configuration mode to select the IS-IS interface
circuit type of adjacency desired for neighbors on the BSR interface (IS-IS interface
circuit type):
MOT(config-if)#isis circuit-type {level-1 | level-1-2 | level-2-only}